24V 10Ah power supply for above-ground roller shutter – AN0610

Description

24V DC power supply producing 220W and 10Ah maximum ideal for powering a swimming pool roller shutter fitted with a motor: UNICUM, SIREM, BECKER… from the brands APF, CAMAROL, DEL, BWT, Everblue, Abrisud, Sofatec, Aqualiss…

Compatible with all motors for automatic above-ground covers(max 10A) with electronic or mechanical sensors.

The AN0610 power supply is compatible with the AN1060 power supply (24V 5A).

This power supply works ideally with the Universal control box for above-ground roller shutters and a Unicum UNIMOT 120nm motor or a Sirem COVEO C 80 80nm motor or a Becker XL60 60nm motor or a Becker XL 120 120nm motor or a Becker XL200 200nm motor.

Specifications

AN610 power supply technical details

Features of the AN0610 :

Lightning protection: As swimming pools are usually located outside buildings, lightning strikes them and the electrical equipment connected to them particularly hard. Our enclosures have reinforced protection against lightning.

Filtered: The direct current needed to operate motors is usually obtained from the mains alternating current, the voltage of which is lowered and rectified. For reasons of cost, entry-level power supplies are content with simple alternating rectification, resulting in a high ripple rate and reduced motor performance.

QR Code: To make installing and using our enclosures as easy and efficient as possible, detailed instructions are available on the Internet. A QR code on the label on the outside of the box gives you easy access.

Detailed instructions

To help you install and use our enclosures as simply and effectively as possible, detailed instructions are available online. A QR code on the label on the outside of the box gives you easy access.

Guarantee

Our products are guaranteed for two years from the date of purchase. If a fault occurs during normal use, we will repair or replace the product after an expert assessment in our workshops.

Manufacture

Our products are designed and manufactured in France. In particular, the important stages of assembling the electronic components, checking the cards and assembling the box are carried out in our workshops.

European standard

European regulations require a high level of safety and quality to guarantee users the lowest possible level of risk. Our products are designed and manufactured to meet these requirements, and carry the CE mark.

Compliance

Safety equipment for access to swimming pools, and shutters in particular, are governed by standard NF P 90-308.