Square end cap for swimming pool bar cover roller

Easily replace the end piece of your pool bar cover roller

This square aluminum end piece is an essential replacement part for pool bar cover rollers. It inserts directly into the roller tube and allows for the crank to be connected to wind and unwind your cover with ease.

Over time and with repeated handling, the drive square can wear out, making the use of the crank more difficult. Replacing this end piece restores smooth and efficient operation to your roller.

A sturdy and lightweight winding square for end pieces

Made of aluminum, this end piece offers an excellent compromise between weight and strength. It resists the stresses of daily use while keeping the roller weight low.

The four stainless steel fixing screws included ensure excellent long-term durability and good resistance to corrosion.

Installation on the bar cover roller is simple

Installing the end piece is quick:

• Insert the end piece into the roller tube.
• Drill through the tube and the end piece to align the fixing points.
• Secure the assembly using the 4 stainless steel rivets provided.

The shank diameter of the rivet is 3.90 mm. We recommend drilling with a 4 mm drill bit.

Once installed, the end piece can accommodate the crank and restores efficient winding of your bar cover.

Why replace your pool roller end piece?

Over the seasons, the drive square wears out naturally due to repeated handling. A worn end piece can cause play with the crank, make winding the cover difficult, or prevent it from functioning properly.

Replacing this part helps extend the life of your roller without having to replace the entire mechanism.